• Welcome to Българският форум за Микротик.
 

RouterOS 5.6

Започната от Joro711, Сряда, 03 Август, 2011, 21:31:10

« назад - напред »

0 Потребители и 1 гост преглеждат тази тема.

Joro711

Нова версия на Mikrotik. Можете да си я свалите от тук.

http://mikrotik-bg.com/files/routeros-all-5.6.torrent

Промени в 5.6 (2011-Aug-02 14:45):

*) fixed ssh server crashing when sessions were interrupted
*) ipsec - fix a problem which could silently remove a manual policy
   from the kernel if the peer configuration has 'generate-policy' set to 'yes'
   and if the policy matches with the traffic selector of a SA being removed
   on the responder side, also fix a problem that some generated policies
   may stay in kernel after relevant SA was removed;
*) profiler - correctly show idle task on RB1200;
*) webfig - fix dual nstreme interface setting lists;
*) webfig - fix Wireless Access/Connect List editing;
*) webfig - fix bitrate presentation in simple queues (show 1.5M as 1500k);
*) fixed micro-sd access on RB400 not to stop everything else;
*) sstp - when server certificate verification is enabled for sstp client,
   it will additionally compare IP addresses found in certificate's
   subjectAltName and subject CN to the real address, DNS names are ignored;
*) tftp - optional block counter roll-over support;
*) hotspot - fixed possible crash in case of multiple Radius CoA requests;
*) userman - speedup user deletion with big log size,
   note that first userman startup after this update
   may take few minutes if the log size is in hundreds of MB;
*) mpls - added support for enabling/disabling control word usage for
  BGP based VPLS tunnels (both - Cisco and RFC 4761 based);
*) mpls - added support for auto-discovery of VPLS NLRI encoding method
  for Cisco BGP based VPLS tunnels;
*) winbox - sometimes after disconnecting, winbox could not connect back;
*) bgp - allow parallel operation of RFC4761 "l2vpn" and
   draft-ietf-l2vpn-signaling "l2vpn-cisco" BGP VPLS variants inside
   single peering session.
*) console - ":resolve" command now returns IPv6 address for domain names
   that have only IPv6 address records;
*) snmp - provide ups alarms for bad or low battery or for ups overload;
*) route - fixed SNMP getnext queries, were failing to find next
   prefix in the OID order;

Joro711